Genie garage door keypad instruction manual

The outside garage door keypad has a flat ribbon, which slides behind the garage door molding into the garage, and attaches to the Keyless Entry Receiver box. Behind the receiver’s cover is a switch. Slide the switch to SET. Enter your PIN on the outside keypad, followed by the “star” button. Slide the receiver switch back to RUN.  · Genie Garage Door Opener Remote Keypad Manual; Genie Garage Door Keypad Troubleshooting “If your Genie opener was made prior to , this is a great time to look at a new model.” If you need a Genie garage door opener manual for your do-it-yourself or dealer installed model, scroll down to the models and click on the link to your manual. Garage Door Opener Programming Instructions Garage Door Opener Remote Programming Outside Keypad Programming Homelink Garage Door Opener Programming.

Genie garage door opener installation instructions Genie Garage Door Opener Parts www.doorway.ru Installer: Leave this manual with homeowner. ALWAYS AT YOUR COMMAND Models // GARAGE DOOR OPENERS Includes: 2-Bulb Light System Wall Console The SilentMax 3/4 Belt Drive Garage Door Opener is the ultra Make this opener a smart garage door with Genie The installation instructions were. Genie Company at: 1 Door Drive, Mount Hope Ohio, or call or visit our website at: www.doorway.ru Keypad MUST be mounted within sight of the garage door(s) at least 5 feet above floor and clear of any moving door parts. • Programming will not be lost during battery removal. 1. Remove battery cover and batteries. 2. The garage door should open/close. *On the keypad, any button will control opening and closing the garage door while the keypad backlight is on (about 30 seconds) after the PIN is entered. If the garage door does not open and close using the wireless keypad, repeat the programming steps Programming Keypad for Multiple Garage Doors (Up to 3).

When the door has stopped moving, pressing on any single button will activate door until backlight goes off (30 seconds). Page 4 GENIE Professional Dealer. To locate a dealer near you–call OK-GENIE. ® ® If the first five digits of your serial number fall between and contact Genie for assistance Step-By-Step Programming Instructions. Reset keypad by sliding the cover half way up. While holding down on the # and 8 keys at the same time slide the cover up the rest of the way until it clicks or latches. Release the # and 8 keys. Close the cover. Open the cover back up and press in order the 3, 5, 7 and # keys. Consult the devices manual if needed. Keypad MUST be mounted within sight of the garage door(s) at least 5 feet above floor and clear of any moving door parts. NOTE that programming will not be lost during battery removal. 1. Remove battery cover and batteries. Replace if necessary. 2. Drill a 3/32” pilot hole for the top mounting screw. 3.